Not long ago, more than 800 people gathered in Madrid, Spain, guests of Siemens PLM Software. The event: an internal conference designed to deliver expert knowledge sharing and hands-on technical training.
For two and a half days employees attended intensive sessions focused on building skill sets, sharing best practices and increasing detailed technical understanding of the full potential of the company’s industry-leading product lifecycle management software options.
And starting just one week later, hundreds of people who weren’t in Madrid attended the sessions as well.
The Challenge: Capturing a large internal conference on video and sharing quickly
The Solution: An all-in-one software-based service for video recording, editing, organizing and sharing
The Result: A complete library of conference videos ready just one week after the event
While hosting 800 people is no small feat, that’s just a fraction of Siemens’ worldwide staff. Realizing that many of the employees that weren’t able to join the conference could benefit from the kind of knowledge shared there, event planners came up with a strategy for recording and sharing the entire conference.
Over three days and across 8 rooms the team recorded and captured 35 speakers and in more than 30 event sessions.
And they did it using only standard webcams, USB microphones, the presenters’ own laptops . . . and Panopto.
Just to be safe, the team brought in their own camcorders as a backup measure. Then they waited for the result. None of the camcorder videos were ever used; the webcams worked.
Here, we tell you how.
First, though, a little background.
While planning their big employee conference in Madrid, Siemens faced a common challenge: how to preserve their valuable presentations in a manner that would be both timely and cost-effective.
Past experience proved this was no small problem. The traditional event recording process presented a number of problems, chiefly:
Due to these persistent problems, Siemens’ conference planners forecast that recreating their conference digitally would take 200 hours of work, and wouldn’t be ready for 30 to 45 days after the event.
And so, the team decided to try something different this time.
They used Panopto instead.
It wasn’t a difficult decision. The Siemens PLM Software Learning & Development team had already been using a small Panopto implementation to help enable the company’s video-based training and onboarding.
With the endorsement of the Learning & Development team, Siemens looked to see what else Panopto could do. And that’s when they began to see how Panopto could help them overcome all three of their event video challenges, too.
Panopto can be installed quickly and easily on any laptop. The software automatically recognizes video and audio recording devices from USB webcams to HDMI video cameras, so anyone can use it anywhere—with just about any device and with minimal setup.
Panopto can record multiple video streams with just one click, then automatically takes care of syncing, encoding, and uploading the video to a secure, searchable video library. Presenters just click “record”, present, click “stop”—and Panopto does the rest.
With Panopto, the conference hosts would be able to serve as their own AV team, recording both the speakers and their accompanying presentation materials themselves. Immediately following the sessions, Panopto would automatically upload everything to Siemens’ video content management system (VCMS). The videos could then be edited using Panopto’s web-based video editor.
After that, it would just be a matter of telling the rest of their employees they were there.
Siemens and Panopto partnered on a three-step, “ready-set-go” plan for implementation.
Ready | Pre-Event Setup
Since none of the 35 presenters were familiar with Panopto, Siemens and Panopto worked together to get everyone ready. Presenters were given a short video instructing them how to download Panopto and connect to the Siemens video library. Presenter preparation was intentionally kept brief to encourage adoption and allow speakers to focus on their sessions.
While Siemens planned on recording with webcams the Learning & Development team already had, an audio solution for 8 rooms was needed. Siemens and Panopto jointly identified and tested USB microphones, and Siemens purchased 10 Blue Yeti USB microphones for the event.
Set | Presentation Days
Recording a conference designed for 800 attendees presents more than a few challenges. For Siemens, those challenges came down to how to best capture two very different environments: large plenary sessions in the main hall, and smaller, scattered concurrent breakout sessions.
For the main sessions, Siemens opted to capture the “big-picture” view. Video and audio for the stage were recorded with a single stage webcam. Speakers’ PowerPoint® slides were added and synchronized in post-production editing with Panopto.
For the breakout sessions, the challenge was set-up time. Each room had to be wired with the Yeti microphone (and the back-up camcorders). Presenters were recorded using their own laptops, each requiring about 3-5 minutes to set up—with only 10 minutes available between sessions.
Despite the lack of experience with Panopto, Siemens successfully recorded all but two rooms in the first round of sessions and from then on saw every session captured in full. Set-up speed improved in each cycle, falling to 2-3 minutes per room by the end of the conference.
Go | Post-Presentation
After the presenters recorded their own sessions, all that was left was to upload the videos to Siemens’ Panopto video library. Although Panopto typically does this automatically, wifi at the conference location was inconsistent and event organizers had opted to record most sessions offline.
With a quick reminder email Siemens saw most presenters upload their recorded sessions right away. No Panopto recordings were lost, and Siemens experienced 100% file transfer success.
Within a week of the conference’s close, the Siemens PLM team had reviewed, edited and shared all of the uploaded sessions.
The plan worked.
Siemens recorded a complete 3-day conference, with individual presentations from 35 speakers across more than 30 sessions, and made the whole thing available to their worldwide workforce in one week’s time.
And they did it with just a handful of standard webcams, their presenters’ own laptops, and Panopto.
For Siemens PLM, the results were ideal.
First and foremost, they’d created a library of more than 30 original, high-quality videos, all with notes, slides, and indexed content, and all captured perfectly.
And they were timely. The Siemens team had successfully recorded, uploaded, edited and organized all of the videos within a week of the conference’s close. Employees unable to attend in person saw it all just a week later — instead of a month and a half after the fact.
And they were searchable! In the weeks that followed, Siemens found that Panopto even made it easy to search inside the event videos. Employees who hadn’t attended could quickly find not only the sessions that interested them, but the exact moments within the sessions that spoke to their interest. Those who had attended meanwhile were able to review their favorite moments.
Best of all was the savings. The old process—which would have required 200 hours of contract work by technical specialists, not to mention almost a dozen thousand-dollar HD camcorders and supporting equipment—was typically a significant part of Siemens’ budget for each event.
Panopto eliminated the need for all of that—all while producing better quality videos and with no new hardware, no technical consultants, and no specialized training.
“Panopto was the only means to record and capture this large of an event on a timely basis with minimum Learning & Development project hours expended,” wrote Thomas P. Doyle, Director of Curriculum Development at Siemens PLM Software.
Indeed, the Siemens Madrid conference was a success—and so were the successive Madrid conferences held online. Shortly after the videos were made available they had been viewed more than 500 times by more than 200 Siemens employees—and counting.
What started out as a tool for the Learning & Development team spread to the Events team and throughout the company, and today Siemens PLM Software is scaling up Panopto enterprise video deployment.